Tag Archives: turnigy

Taking the DIY E-Bike Off-Road (and into the water)

There have been a few questions about this ~300w ebike and the places it can go.  I try to address some of those through experimentation in this video.

Among the tests done, I go over a few speed bumps, jump the curb, zip through some uneven grass, displace some sand, and hit the waves. All on two wheels.

Continue reading Taking the DIY E-Bike Off-Road (and into the water)

Tricopter build log part two

The frame is now prototyped and measurements are almost final. Several small changes were made to the source files as result of this prototype (now on internal-revision #24). These changes included primarily wider tolerances and smaller hardware requirements. Other potential ideas are still pending (in particular; optional “taller” landing struts, ESC/wire management, and AIO mounting).

DSC_0025-main2

Changes to the last update included primarily, universal motormounts. Now it’s not necessary to use a specific cross plate on a limited range of motors. I’ve adopted the standard 16/19mm hole spacing used on many motors appropriate for this size multicopter. Also, the mount’s face is now flat on both sides, so you can more easily mod them (drill holes) for a specific motor that doesn’t follow these standards. With this, you will need to use 8mm M3 socket cap screws (instead of the shorter, countersunk M3 screws often provided with your motors) to mount said motors to the mounts.

The arms fold back too!
Continue reading Tricopter build log part two

Tricopter build log part one

The frame still needs to be prototyped on my printer, though I have modeled the finished project to get an idea of the size.

progress

The distance between motor-centers is roughly 625mm when the two front 1/2″(12.7mm) wood dowels are cut to 350mm and the tail to 310mm (-40mm). This was necessary to accommodate the inline motor hinge that pivots on the axis of the tail arm. These dimensions, along with other things, are subject to change after the prototype gets printed.

I modified Thingiverse user ennui2342’s tricopter body, based off of David Windestål’s RCExplorer tricopter, to support the stronger, more common 1/2″ wood dowels. Other minor modifications to the body were made as well.  I also loosely based my landing gear/motor mounts off of jphillips’ designs. The shock absorbing bottom plates (optional setups for FPV shown above) are unique to this tricopter.

Continue reading Tricopter build log part one