You now have everything you need to build LiTeRo, the Little Telepresence Robot! The code is now fully commented and ready to teach you everything you need to know about Python and Raspberry Pi powered telepresence robots. You are free to modify and share changes with the community here or on GitHub.
Code and Raspberry Pi setup available on GitHub here:
Full writeup and build videos here:
3D printable files on Thingiverse here:
After almost four years living in university dorms, I am left aching to hack a place of my own. As expected, I eventually decided to automate my dorm room window blinds.
What came of it was a fanciful bit of ultra-lightweight Arduino code.
Be sure to visit the full write-up page for more details.
At the heart of this CommandStrip-stuck gadget is one original Adafruit Trinket microcontroller sporting a feeble ATTiny85. It sits next to a generic A3988 stepper motor driver.
Continue reading Using a Trinket to control a stepper motor with acceleration – Dorm automation
Solenoid engines are nothing new, though they still seem to be a fairly common project among the curious. Using a hard drive makes such a project much more simple and straight forward, that is if you want to keep it that way.
This solenoid engine uses a software control loop (code below) running on a 16MHz Adafruit Trinket to adjust its speed. The program specifically alternates between a modest 180RPM to a smashing 3000RPM every five or ten seconds! Watch the video below!
Continue reading Hard Drive Solenoid Engine With Trinket
On October 21 the Hack a Day blog announced a contest where readers can slap the blog’s logo on something and win Trinkets that were supplied by Adafruit Industries. There were
twenty 41 Trinkets to give away in this contest and preference was given to both the smallest and largest of the entries. The deadline was November 1st and being the busy college student that I was with not much time on my hands, I decided to just sit back and watch the entries roll in.
At around 9pm on October 31, with only three hours left in this contest, I suddenly got the urge to enter. Not a minute later I came up with a very simplistic idea for a universal pen plotter based off my 3D printer and the software I normally use with it.
Continue reading Pen-plotting for the Hack a Day/Adafruit Trinket Contest