Tag Archives: 3d print

Tricopter Build Log part three

DSC_0355

It’s alive! The tricopter went under a few more revisions and prints before finally taking to the air. My old Rev One Quadcopter has been reduced to it’s (over-engineered) frame and nothing more. Its parts (motors, ESCs, batteries, Crius AIO, etc.) have moved on to become this very tricopter.

Currently (in the picture) it is set up to fly FPV sans-GoPro. There is an optional part available to replace the camera pan/tilt servo mount/hole with an alternative “use-what-you-want” vibration-dampened plate.

Keep reading for a couple closeups and highlights of the tricopter.

Continue reading Tricopter Build Log part three

Tricopter build log part two

The frame is now prototyped and measurements are almost final. Several small changes were made to the source files as result of this prototype (now on internal-revision #24). These changes included primarily wider tolerances and smaller hardware requirements. Other potential ideas are still pending (in particular; optional “taller” landing struts, ESC/wire management, and AIO mounting).

DSC_0025-main2

Changes to the last update included primarily, universal motormounts. Now it’s not necessary to use a specific cross plate on a limited range of motors. I’ve adopted the standard 16/19mm hole spacing used on many motors appropriate for this size multicopter. Also, the mount’s face is now flat on both sides, so you can more easily mod them (drill holes) for a specific motor that doesn’t follow these standards. With this, you will need to use 8mm M3 socket cap screws (instead of the shorter, countersunk M3 screws often provided with your motors) to mount said motors to the mounts.

The arms fold back too!
Continue reading Tricopter build log part two